Complex front angles and scribing require an accurate full-size plan.
Project library / Storage & cabinets
Corner Bookcase Cupboard
A fitted two-door corner cupboard supporting a tall open bookcase set back to clear room trim.

What makes this build.
Complex front angles and scribing require an accurate full-size plan.
The open upper section steps back relative to the lower cupboard.
Points to resolve before building
- MDF is heavy; plan lifting help and wall anchorage. Verify the unusual printed chamfer angle from the diagram before cutting.
Materials & tools.
Check what you have, then confirm stock sizes and hardware against your chosen dimensions.
Materials checklist
Tools & operations
- Guided circular saw
- Drill
- Clamps
- Bevel gauge
- Level
Tool choices may include practical editorial suggestions. Use workholding and guarding appropriate to the actual machine and operation.
Choose dry, sound stock and test unfamiliar joints in scrap. Keep guards, push aids, eye protection, and dust control appropriate to the work.
Measurements to know.
Selected dimensions verified from the source. This is not an automatically scaled cutting list.
| Lower backs | 882 × 800 mm and 882 × 782 mm | Source p. 2 |
|---|---|---|
| Upper backs | 1740 × 665 mm and 1740 × 649 mm | Source p. 3 |
| Lower floor position | 90 mm above the bottom | Source p. 2 |
Printed diagrams and concept images are not scale references. Verify measurements, material thickness, hardware fit, and allowances before cutting.
Inches to millimeters
Convert a measurement without changing the design. Enter a decimal or a fraction, such as 1 3/8.
Nominal lumber names and actual finished sizes are different. Converting units does not choose a substitute stock size.
Let’s make it.
Read the complete sequence before cutting. Mark a stage complete after its fit checks and any required glue cure.
Template the actual room
- Draw the corner footprint full-size and include skirting thickness. Keep the upper section setback distinct from the lower section instead of assuming their backs align. Compare every angled part against the same plan so small angle errors do not accumulate across the front.
Build the lower shell
- Join the overlapping backs and set the floor ninety millimeters up. Make the three-piece front top rail with its notches for the vertical hinging rails. The rail also braces the shell while the sides are removed for scribing, so check it before installation.
Fit the lower doors and sides
- Shape the hinging rails and mating side edges to the drawing, verifying the source’s angle convention on scrap. Temporarily fit the sides for scribing to the wall, then mount the top and doors. Keep the scribed sides removable until their wall fit is settled; forcing them against a crooked wall can distort the doors.
Assemble the upper bookcase
- Join the upper backs and brace them with the top triangular shelf and a fixed middle shelf. Fit the fascias and provide the remaining adjustable shelves. The top and fixed middle shelf brace the back panels; keep that structure square before laying out adjustable supports.
Install and finish
- Secure both sections to appropriate wall structure, then fit cornice, scotia and skirting. Seal MDF edges thoroughly and adjust door catches after finishing. Recheck the two-section alignment before concealing the joint with trim, and keep door edges clear of the final paint film.
Progress and notes stay in this browser. Nothing is uploaded.
Source notes.
- Original PDF
- Corner Cabinet 2.pdf
- Source length
- 5 pages
- Attribution
- Collection copyright 2004 Martian Auctions; original authorship unverified
- This edition
- 116 Studio · Original written companion and AI concept image · November 2026
Page references count from the first page of this PDF. The original is retained in the owner’s private woodworking collection; it is not distributed by this website. Consult it for full drawings, templates, and details beyond this companion.
Historical plans can omit essential context. Source references identify where a detail came from; they do not certify the design or replace current manufacturer instructions or applicable professional review.