Two gate assemblies and six leaf hinges must be aligned together.
Project library / Tables & desks
Oval Gate-Leg Table
A compact veneered table whose two semicircular leaves rest on hinged gate legs.

What makes this build.
Two gate assemblies and six leaf hinges must be aligned together.
The oval top is made from a rectangular center and two semicircles.
Points to resolve before building
- Do not rely on loosely positioned gate legs; stops and hinge fastenings must be secure.
Materials & tools.
Check what you have, then confirm stock sizes and hardware against your chosen dimensions.
Materials checklist
Tools & operations
- Saw
- Jigsaw
- Drill and dowel jig
- Plane
- Clamps
Tool choices may include practical editorial suggestions. Use workholding and guarding appropriate to the actual machine and operation.
Choose dry, sound stock and test unfamiliar joints in scrap. Keep guards, push aids, eye protection, and dust control appropriate to the work.
Measurements to know.
Selected dimensions verified from the source. This is not an automatically scaled cutting list.
| Top panel blanks | Three at 760 × 380 × 18 mm | Source p. 1 |
|---|---|---|
| Leaf radius | 380 mm | Source p. 1 |
| Leg cut length | 690 mm | Source p. 5 |
Printed diagrams and concept images are not scale references. Verify measurements, material thickness, hardware fit, and allowances before cutting.
Inches to millimeters
Convert a measurement without changing the design. Enter a decimal or a fraction, such as 1 3/8.
Nominal lumber names and actual finished sizes are different. Converting units does not choose a substitute stock size.
Let’s make it.
Read the complete sequence before cutting. Mark a stage complete after its fit checks and any required glue cure.
Build the fixed frame
- Mark all six legs together, then drill the paired dowel joints. Assemble the fixed long sides and connect them with the short end rails. Keep the fixed-frame rails separate from the gate rails, and use the dry fit to check their different functions and clearances.
Make the gates
- Join each swinging leg to its top and bottom rails. Fit the hinges provisionally and check the two gates can nest inside the base. Test the folded positions with both gates installed, since a gate that swings freely alone may still foul its opposite partner.
Shape and veneer the top
- Cut two semicircular leaves and one rectangular center. Apply edge veneer and face veneer according to the selected product’s current instructions. The two semicircles must match so the opened tabletop reads as one oval, and exposed sheet edges need continuous covering.
Fit leaf hinges
- Lay the panels face-down and install the three hinges per leaf with screws short enough to stay below the top surface. Attach the center panel to the fixed base. Check hinge alignment with the panels both flat and lowered before fully tightening the screws and mounting the center section.
Set the gate stops
- Swing each gate beneath its raised leaf and fit the stop blocks to the actual assembly. Finish and verify positive support before loading a leaf. The stop blocks must locate the gates directly beneath their load-bearing positions rather than allowing them to swing past the leaves.
Progress and notes stay in this browser. Nothing is uploaded.
Source notes.
- Original PDF
- Gate Leg Table.pdf
- Source length
- 6 pages
- Attribution
- Collection copyright 2004 Martian Auctions; original authorship unverified
- This edition
- 116 Studio · Original written companion and AI concept image · November 2026
Page references count from the first page of this PDF. The original is retained in the owner’s private woodworking collection; it is not distributed by this website. Consult it for full drawings, templates, and details beyond this companion.
Historical plans can omit essential context. Source references identify where a detail came from; they do not certify the design or replace current manufacturer instructions or applicable professional review.